Disassembly; Switching On And Off; Application; Preparation - Proceq ZAA 2300 Instruction Manual

5.1 Disassembly

To prevent transport damage, the weight (7) and the glass plate / heating plate
have to be removed:
•
Loosen and remove the knurled screw (11) to
remove the weight (7). First turn the weight
upwards by 90 ° and – in reversed order as at the
assembly - first take one side of the weight then
the other out of the guides.
•
Remove the glass plate / heating plate.
•
Slide the clamping device (5), the drawing unit (19)
and both stops (1 & 2) to the middle of the device.
•
Only transport the device in its original packaging.
Disassembled device before and after transport:

5.2 Switching on and off

•
Make sure that the apparatus is connected to a power socket with the supplied
power cable (17).
•
Turn the FWD-STOP-REV button (13) to the STOP position.
•
Switch on the main switch (16) at the back of the apparatus. The operation
light (15) glows green, the device is ready to use.
•
Switch off the device after the last application at the main switch (16). The
operation light (15) extinguishes, the device is off.
6

Application

6.1 Preparation

Before the apparatus is prepared for application, you should have decided:
Page 16
(11)