Table of Contents
Advertisement
8.3 Lubrication of the guide rods
From time to time it can be necessary to lubricate the guide rods with some sewing
machine oil or something similar.
Before lubricating the guide rods of the Proceq ZAA 2300, always switch off
the apparatus and unplug it.
No oil shall be sprayed into the apparatus. The function of electrical or
mechanical components could be impaired.
For lubricating proceed as follows:
•
Remove the inserted plate (see also chapter 7 "Turning the glass plate" on
page 23).
•
Turn the apparatus carefully on one side so that the side opening of the cover
becomes accessible.
•
Put some drops of sewing machine oil on your finger and spread it over the
whole length of the guide rods.
•
Repeat this for the other side of the apparatus.
•
Adjust the start stop (1) at the very beginning and the end stop (2) at the very
end and move the drawing unit (22) back and forth several times, so that the
oil gets distributed evenly over the whole length of the rods.
•
Insert the required plate.
8.4 Replacing the fuse
If the apparatus cannot be switched on (operation light POWER (15) is not glowing,
this could be due to a defect fuse. You can replace the fuse by yourself by opening
the fuse holder (18) on the back of the apparatus between the main switch (16) and
the power supply socket (17) carefully using a screw driver or a similar tool.
Before replacing the fuse, always switch off the apparatus and unplug it.
Replace the fine fuse (18) only by an equivalent fuse of the same type
with the same specification. Make sure that the inscription at the
connection caps of the fuse corresponds to one of the following
designations:
•
T 0.8 A / 250 V
•
T 800 mA / 250 V
•
T 800 / 250 V.
Page 25
Advertisement
Table of Contents
