Setting And/Or Changing The Passcode - Suzuki DF140A Owner's Manual

SETTING AND/OR CHANGING THE PASS-
CODE
By setting a 4-digit passcode, the engine can
be started by entering the passcode even if the
key-fob battery has run down or the key-fob is
lost.
The same method is used to set and change
the passcode.
NOTE:
Carry the passcode with the emergency key in
case the key-fob battery runs down or the key-
fob is lost.
NOTE:
When the passcode has been updated or
changed, the previous passcode is deleted and
updated to the new passcode.
Use the following procedure to set or change
the passcode:
1. Confirm the engine is stopped.
2. Make sure the emergency switch lock plate
is in place.
3. Confirm the key-fob is within the communi-
cation range of the Keyless Start System.
4. Confirm that the key-fob is in communication
ON mode. (Refer to "Switching the commu-
nication mode of the key-fob" section.)
5. Turn the main switch to the "ON & OFF"
(" ") position and then release it. The main
switch automatically returns to the "PUSH
START/STOP" position.
The buzzer on the engine control side emits
one (1) long sound while the buzzer on the
keyless control unit side emits two (2) short
sounds simultaneously.
If equipped with side mount type
remote control box:
PUSH
START
ON & OFF
STOP
PUSH
START
ON & OFF
STOP
If equipped with top mount type
remote control box: (Main switch panel)
PUSH
START
STOP
6. Pull out the emergency stop switch lock
plate.
7. Within eight (8) seconds after performing
Step 5, start the following operation.
(1) Turn the main switch to the "ON & OFF"
(" ") position and hold it for about five (5)
seconds then release it to the "PUSH
START/STOP" position.
Repeat this operation for two more times.
The buzzer sounds once and the system
enters stand-by mode for passcode input.
NOTE:
The buzzer will not sound if the operation in
Step (1) is not performed within eight (8) sec-
onds or the operation fails.
PUSH
START
STOP
19