Houghton BELAIRE H3400 Owner's Manual page 19

LED lighting function
Press the " LIGHT " key, the plenum LED lighting will turn on.
●
When LED lighting is on, press the " DIM " key to select 25% / 50% / 75% / 100% brightness. The plenum LED
●
lighting will display different levels of brightness.
Press the "LIGHT"key again，the plenum LED lighting will turn off.
●
When only DC power supply, the
●
DC mode;
When the DC voltage of the battery is less than 10.8 V, the LED lighting is fixed at 25% brightness and can not be
●
adjusted.When the DC voltage of the battery returns to 11.4 V or more,the LED lighting
normally.
WIFI function ( valid only for units with WIFI function)
Turn on the remote control , enter into WIFI connection mode by pressing the "℃/℉" and "LOCK" keys simultaneously
●
for 6s. The indicator light on plenum will show " SC " and rapidly blink. Connect WIFI with mobile, open the APP, add
device, click"confirm". Please refer to WIFI operation instruction for detailed instructions.
Timing function
Set clock and timer.
●
Press the "SET TIME" key, the Hour digit will flash. Press "▲"or"▼"key to set hour. Press the "HOUR/MIN" key,
1
the Minute digit will flash. Press"▲"or"▼"key to set minute. Clock setup is done.
Press the " SET TIME " key, until "ON" shows on the upper right side of the clock and hour digit flashes. Then press
2
the "HOUR/MIN" key, and "▲"or"▼"key, to set the desired time to turn the unit on.
3 Press the SET TIME" key, until "OFF" shows on the lower right side of the clock and hour digit flashes. Then press
"
the "HOUR/MIN" key, and "▲"or"▼"key, to set the desired time to turn the unit off.
4
Clock and timer is now set. Keep on pressing the SET TIME" key to check again clock and programmed time to turn
unit on and off. When all setup is done, after 10 flashes, it will return to clock display.
Timing to turn on : Press the"TIMER" key until "ON" flashes and shows the time to turn on. When "ON" is displayed
●
after its 10 flashes, and only current clock is displayed, then the setup of timing to turn the unit on is done.
Timing to turn off : Press the "TIMER" key until "OFF" flashes and shows the time to turn off. When"OFF" is displayed
●
after its 10 flashes, and only current clock is displayed, then the setup of timing to turn the unit off is done.
Timing to turn on and off : Press the "TIMER" key until "ON" and "OFF" flashes simultaneously and shows the time to
●
turn off. When "On" and "OFF" are displayed after their simultaneous 10 flashes, and only current clock is displayed, then
the setup of timing to turn the unit on and off is done.
Turn off timing function: Press the "TIMER" key, when it only shows the clock, the timer function is turned off.
●
Simple method to reset the timer function : remove battery from the remote control , and then replace , The remote
●
control will be restored to the factory settings, and the timer function is turned off.
plenum display will show
"
16
"--". Only LED lighting work when the air-conditioner is in
brightness can be adjusted