Setting The Squelch Level - Icom IC-V10MR Operating Manual

2
BASIC OPERATION

■ Setting the squelch level

The squelch circuit mutes the received audio signal, de-
pending on the signal strength.
Rotate [VOL] to turn the transceiver power OFF.
q
[ROTARY SELECTOR] to any channel other than
Set
w
Channel 16.
While holding down
e
power and enter the squelch level adjustment mode.
[Upper] to increase the squelch level (tight squelch),
Push
r
or push [Lower] to decrease the squelch level (loose
squelch).
• The adjustable range is 0 (loose squelch) to 9 (tight squelch).
• A beep sounds after pushing [Upper] or [Lower]. An error
beep sounds if you try to exceed the adjustable range. There-
fore, you can determine the current level setting by the increas-
ing loudness of the beep that sounds.
Rotate [VOL] to turn OFF the power, then ON again to exit
t
the squelch level adjustment mode.
NOTE: This operation may not be selectable, depending
on the presetting. Ask your dealer for details.
11
[Upper], rotate [VOL] to turn ON the
[ROTARY SELECTOR]
[Upper]
[Lower]
[VOL]