If You Cannot Operate With The Remote Control - Toto G500 Instruction Manual

What to Do?

If you cannot operate with the remote control

If you cannot operate with the remote control
Operation is also possible using the buttons on the
■
Washlet control panel.
● The batteries may have worn out. Replace the batteries.
(P.14)
Replacing the batteries
■
1
Press on the Washlet control panel.
● • The POWER LED goes off.
2 Remove the remote control from the
hanger.
(Page 14)
Open the cover and replace the AA
3
batteries.
(Page 14)
4 Mount the remote control in the hanger.
5
Press on the Washlet control panel.
● • The POWER LED lights up.
About the batteries
■
Use dry cell, alkaline batteries. Follow the instructions below to prevent the batteries from rupturing or leaking fluid.
●
•
When replacing the batteries, use new batteries of the same brand.
• If you will not be using the remote control for a long time, remove the batteries.
•
Do not use rechargeable batteries.
52
When Not Using for a Long Time
If you are leaving your home in the winter, for example when going on vacation, be sure to drain
the water to prevent freezing.
Also, if the toilet is in a location you will not visit for a long time, drain the water.
(The water in the tank may become contaminated and cause skin inflammation or other problems.)
1 Close the water supply valve.
(Page 54)
Release the pressure from the
2
water supply hose.
Refer to procedure 2 "Release the pressure
from the water supply hose" on page 33.)
3 Drain the pipe.
1.
INTEGRATED WASHLET
Main display
The POWER LED lights up.
2.
3.
4.
4 Disconnect the power plug and
take steps to deal with the water
remaining in the bowl unit.
Putting antifreeze in the water remaining in the
bowl unit will reduce its chances of freezing.
How to drain the water
When you use Washlet again, the
■
water supply and power supply will be
required. (See below)
Remove the cover.
Cover
Remove the water filter drain valve.
Water filter
drain valve
Flat-head screwdriver
Dustcloth, etc.
After draining the water, reinsert the water
filter drain valve.
Tighten it securely using a flat-head
screwdriver.
Install the cover.
Cover
Resupplying the Water (After draining)
Open the water supply valve.
1
(Page 15)
Check that there are no leaks in the
plumbing or the Washlet.
Insert the power plug.
2
3
Discharge water from the
wand.
While pressing the right side of the toilet
seat, press the "REAR" button on the
remote control to discharge water from
the wand. (Catch the water in a paper
cup or another receptacle.)
If the remaining water has frozen and
no water comes out, heat the inside
of the bathroom, and warm the water
supply hose and water supply valve
using a cloth soaked in warm water.
4 Press [FULL FLUSH] on the
remote control to flush.
If there is no water in the tank, you
•
cannot flush the toilet. Never operate
the toilet with no water in the tank.
When the tank is filling with water, the
LED on the main display will flicker.
After the tank is full, the LED changes.
(Tank filling time: approx. 60 seconds)
5
After the bowl unit fills with
water, press [FULL FLUSH]
once more.
53