Preparation
Using the Washlet for the First Time
1. Insert the battery.
1
Remove the remote control
from the hanger.
Hanger
2
Open the battery cover and
insert two AA batteries.
AA batteries x2
Close
Open
Battery cover
3
Mount the remote control in
the hanger.
About the batteries
■
●
Use dry cell, alkaline batteries. Follow the
instructions below to prevent the batteries from
rupturing or leaking fluid.
•
When replacing the batteries, use new batteries of
the same brand.
•
If you will not be using the remote control for a long
time, remove the batteries.
•
Do not use rechargeable batteries.
14
When the remote control is locked to
prevent theft
1
Remove the screw from the
remote control fixture.
(Side view)
Remote control
Wall
Hanger
Screw
Loosen
Phillips screwdriver
2
Remove the remote control
from the hanger.
To return
●
•
Tighten the screw. (Overtightening may
cause damage to parts such as the hanger.)
2. Turn on the power.
1
Insert the power plug.
•
The wand extends and then retracts.
2
Check that the POWER LED
on the main display is lit up.
•
If the LED is not lit up, pressing [POWER
ON/OFF] will light it up.
3. Open the water supply valve.
1
Fully open the water supply
valve.
15