Draining V-Belt Cover; Tires; Wheels - Tracker Off-Road 600 Operator'smanual

11. Re-tighten the two Torx T40 bolts in
the forward storage compartment.
Replace the right-side panel and the
vehicle seat.

Draining V-Belt Cover


NOTE: If the ATV has been driven
through water, the V-belt cover must
be drained of any water.
1. Place the ATV on a level surface.
2. Remove the drain bolt from the cover
and allow the water to drain out.
3. Shift the range lever to the neutral
position; then start the engine.
4. Increase and decrease engine RPM
several times to "blow out" any
water; then stop the engine.
5. Install the drain bolt and tighten
securely.

NOTE: The V-belt and pulleys
should be inspected every 500 miles
(800 km) and the belt replaced (if
necessary).

Tires

! WARNING
Always use the size and type of tires
as specified. Refer to the appropriate
Specifications Chart for proper tire
inflation pressure, and always main-
tain proper tire inflation pressure.
Tire Tread Condition
The use of worn-out tires on an ATV is
very dangerous. A tire is considered to be
worn out when the depth of the tread is
less than 3 mm (1/8 in.). Be sure to
replace the tires before reaching this min-
imum specification.
The use of worn-out tires can be dan-
gerous and can increase the risk of
an accident.
Tire Replacement
The ATV has low-pressure tubeless tires.
Have this maintenance performed by a
qualified tire repair station.
OHA035
Use only
replacing tires. Failure to do so
could result in unstable ATV opera-
tion.
Tubeless Tire Repair
Should a leak or flat tire occur due to a
puncture, the tire may be repaired using a
plug-type repair. If the damage is from a
cut or if the puncture cannot be repaired
using a plug, the tire must be replaced.
When operating the ATV in areas where
transportation or service facilities are not
readily available, it is strongly recom-
mended to carry a plug-type repair kit
and a tire pump along.

Wheels

1. Park the ATV on level ground and
engage the brake lever lock.
2. Loosen the lug nuts on the wheel to
be removed.
3. Elevate the ATV.
4. Remove the lug nuts.
5. Remove the wheel.
6. Install the wheel and install the lug
nuts.
! WARNING
! WARNING
approved
0732-649
tires when
63