Tracker Off-Road 600 Operator'smanual page 43

If the ATV is equipped with a manual 4WD
Lock feature: To engage the lock from
4WD, slide the switch up and move fully
to the left. To disengage the lock, move
the switch lever to the right. The lock
position will be indicated on the LCD
gauge.
CAUTION
Do not attempt to either engage or
disengage the manual 4WD Lock
while the ATV is moving.
Hand Brake Lever/Brake
Lever Lock
The hand brake is considered to be the
normal operating (main) brake. It should
be applied whenever a braking situation
is needed.
Apply the brake by compressing the
brake lever toward the handlebar.
To engage and release the brake lever
lock, use the following procedure:
1. Depress and hold the brake lever
lock.
2. While holding in on the brake lever
lock, squeeze the brake lever.

NOTE: It will click as it engages
and the brake lever will not return to
its released position.
3. Attempt to push the ATV. Check to
make sure the brake lever lock
engages properly and that the brake
(when engaged) locks the wheels.

NOTE: The brake lever lock must
lock the wheels. If it doesn't, take
the ATV to an authorized dealer for
service.
Always check to be sure that the
brake lever lock has been disengaged
before operating the ATV. An accident
could result if the brake lever lock is
left engaged while the ATV is oper-
ated. The brake may relax if left
engaged for a long period of time.
This could cause an accident; there-
fore, do not leave the ATV on a hill
depending on the brake lever lock.
Always block the downhill side of the
wheels if leaving the ATV on a hill or
park the ATV in a sidehill position.
4. Release the brake lever lock by
squeezing the brake lever. It will
return to its released position.
Headlight Switch
CF301A
With the ignition switch in the LIGHTS
position, use the headlight switch to
select the high or low headlight beam.
Emergency Stop Switch
OFF position — The ignition circuit is off.
The engine cannot be started or will not
run. If the emergency stop switch is used
to stop engine without turning off ignition
switch, the battery may discharge.
RUN position — The ignition circuit is
on. The engine can start and run.
! WARNING
CF295C
XR071B
41