Tracker Off-Road 600 Operator'smanual page 56

3. Remove the drain plug from the back
of the engine through the access hole
in skid plate and drain the oil into a
drain pan.
4. Using the oil filter wrench and a
ratchet handle (or a socket or box-
end wrench), remove the old oil fil-
ter (see illustration OHA016) and
dispose of properly. Do not re-use
oil filter.

NOTE: Clean up any excess oil
after removing the filter.
5. Apply oil to the new filter O-ring
and check to make sure it is posi-
tioned correctly; then install the new
oil filter. Tighten to 10-12 ft-lb
(13.5-16.3 N-m).
6. Install the engine drain plug and new
gasket; then tighten to 16 ft-lb (21.8
N-m). Remove the oil filler plug
being careful not to let contaminates
enter the opening; then pour ACX All
Weather Synthetic oil in the filler
hole. Install the level stick.
7. Start the engine (while the ATV is
outside on level ground) and allow it
to idle for a few minutes.
8. Turn the engine off and wait approxi-
mately one minute. Recheck the oil level.
54
9. Inspect the area around the drain plug
and oil filter for leaks.
Front Differential
Lubricant (Inspecting/
Changing)
Inspect and change the gear lubricant in
each according to the Maintenance
Schedule. When changing the lubricant,
use approved SAE 80W-90 hypoid oil
and use the following procedure:
OHA016

NOTE: The fill plug is located on
the front left side of the differential.
1. Place the ATV on level ground.
2. Remove fill plug.
OHA017
3. Drain the oil into a drain pan by remov-
ing the drain plug through the access
hole in the skid plate. Clean away any
debris that may have accumulated onto
the magnetic end of the plug.
4. After all the oil has been drained,
install the drain plug and new O-ring;
then tighten to 45 in.-lb (5 N-m).
Inspect the oil for any signs of metal
filings or water. If found, take the ATV
to an authorized dealer for servicing.
CAUTION
OHA018
OHA019