Air Line - Snorkel A46JRT Operator's Manual

Chapter 8 – Operation

Air Line

The optional air line may be used to conduct air for tool
operation at the platform.
• The input connector is at the rear of the chassis and
the output connector is at the platform on the rotator
guard.
• The maximum working pressure of the line is 250 psi
(1,723 kPa).
The air line may be used to conduct fluids such as water
or antifreeze. Contact Snorkel for compatibility information
before using the air line to conduct other fluids.
Caution
Fluid in the air line may damage some air tools or
freeze and damage the line. Drain and blow out the
air line after using it to conduct fluids.
Use the following procedure to drain the air line.
1. Close the input connector on the rear of the turn-
table.
2. Open the output connector at the platform.
3. Raise the riser and main booms slightly above hori-
zontal.
4. Open the input connector on the turntable.
5. Allow the fluid to drain from the line.
6. Lower the boom and close both connections.
36 A46JRT – 0261169