Horn; Electrical Power Outlet; All Motion Alarm; Air Line To Platform - Snorkel TB60 Operator's Manual

4. Hold the engine/emergency power switch in the
emergency power position and step on the platform
foot switch to verify operation of the aerial platform
using the emergency power system.

Horn

The machine may be equipped with an optional horn
(refer to Figure 7.23).
Operate the horn to ensure that it sounds to warn
y
personnel in the area.
Machine/Generator
Switch
Figure 7.23 – Upper Controls

Electrical Power Outlet

Connect a source of 110 volt AC power to the power-
input connector on the left side of the wiring box (refer
to Figure 7.24).
Figure 7.24 – Wiring Box
Some machines may have an electrical cable already
plugged into the outlet on the lower control panel. In that
case, power is supplied by an optional AC generator. An
external power source is not required.
With the engine running, place the optional machine/
generator control (refer to Figure 7.23) in the generator
position to provide electrical power to the two electrical
outlets at the platform.
TB60 – 0083739
Plug an electrical tool into the receptacle at the platform
and try to operate the tool to verify proper operation of
the outlet.
The outlet is equipped with a ground fault circuit inter-
rupter (GFCI). Use the following procedure to test the
GFCI.
1. Push the test button (refer to Figure 7.25).
Horn Button
2. Plug an electrical tool into the outlet and verify the
power is off.
If the power is off, push the reset button to restore
y
power.
If the power is on, repair or replace the recep-
y
tacle.

All Motion Alarm

The machine may be equipped with an all motion
alarm.
Operate machine functions to ensure that the alarm
y
sounds to warn personnel in the area that the aerial
platform is in motion.

Air Line to Platform

The machine may be equipped with an optional air line
to the platform.
• Inspect the components, including the air line, mount-
ing hardware, and the caps on the input and output
connectors, etc. to verify all components are present
and are in working condition.

Driving and Platform Work Lights

The machine may be equipped with driving lights and/or
platform work lights.
• Turn the engine on and use the switch on the back
of each light to momentarily turn it on to see that it
works.
Chapter 7 – Prestart Inspection
Reset Button
Test Button
Figure 7.25 – Electrical Outlet
39