Using The Parking Brake; Installing The Safety Flag; Installing The Cover - Burley BEE Owner's Instruction And Safety Manual

Using the Parking Brake

For All Trailers Except the Bee
Engage the parking brake by pushing the handle to the right. This pushes
the brake arms outward so that the tip of each brake engages the inside of
each tire. Exercise caution when disengaging the brake, as it may spring to
the left.
To disengage
the brake, move
the handle to
the RIGHT.

Installing the Safety Flag

Bee Only:
™
On the outer left side of the trailer, insert the safety flag pole through the
webbing loop and into the flag pocket.
All Other Models:
Insert the safety flag pole into the hole in the top of the LEFT handle bar re-
ceiver. (See handle bar illustration on page 12 for location of correct hole.)
DO NOT USE YOUR TRAILER WITHOUT THE SAFETY FLAG.

Installing the Cover

Cover Snap Button
1
B U R L E Y T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
™
Simply move the
handle to the
LEFT to engage
the brake.
Bee :
™
Snap the cover snap buttons to the
snap posts on the top of the frame.
Attach the cover's Velcro hook strips
to the Velcro loop strips on the trailer
body. Then hook the rubber O-rings
over the back and front frame ends. To
stow the window, unhook the O-rings
from the trailer front. Roll the window
up and secure it by inserting it into the
elastic loops at the top.
Buckle
All Other Models:
Slip D-rings on the front cover corners over the outer hooked corners of the
front tongue receptacles. Attach male buckles on rear cover corners to fe-
male buckles below the side windows. To stow the front window (all models
except the Bee), unzip it, roll it up and insert the loop Velcro ends of the
elastic straps into the hook Velcro holders on the cover top. The Adjustable
Sunshade slides up and down as needed.
D-RINGS:
d'Lite
™
™
Ladybug
Solo
™
Encore
™
B U R L E Y T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
Cub :
™
Snap the two front snap buttons
to the two snap studs under the
front rim corners. Attach the male
buckles on the rear cover corners to
the female buckles below the side
windows.
Snap Buttons
1