Changing The Gobo - ADJ FOCUS SPOT ONE User Manual

Focus Spot One
The gobos in this unit are interchangable. Please be very careful when replacing the gobo.
Caution! Never open the unit when in use. Always disconnect the main power before attempting to
change the gobos.
1. To change a gobo, rotate the moving head so that the UV lens is located on top. Unscrew the
single middle screw. See Step 1 in the Removing the Head Casing section of this manual.
2. Once you loosen the single screw you are able to swing the head back. See step 2 in the Re-
moving the Head Casing section of this manual. You will now be able to access the gobo wheel.
Turn the wheel with your hand until you come across the gobo you would like to change.
3. To remove the gobo holder gently pull the gobo holder towards the front of the unit and slide it up
and out.
4. Gently and carefully remove the retainer ring. After the retainer ring is removed, carefully remove
the gobo.
5. Change the gobo and replace the retainer ring. Carefully slide the gobo holder back into the
housing slot.
6. Reassemble the unit.
ADJ Products, LLC - www.adj.com - Focus Spot One User Manual Page 29

Changing the Gobo