Change Display Language; Energy Saver Mode - Bunn Crescendo Programming Manual

CHANGE DISPLAY LANGUAGE

The display language can be changed in the PROGRAMMING MENU.
NOTE:
Software version 00.46 has these languages available:
English, Spanish, French Canadian, French European, German, Portuguese, Simplified Chinese.
NOTE:
Traditional Chinese, Japanese and Korean are available, but they require a special display module.
To access the "SELECT LANGUAGE" menu:
1. Open the door and place
the NORMAL/PROGRAM/
RINSE switch in the
PROGRAM position.
2. Press buttons 1-5-9-10 in
sequence. (Figure 2)

ENERGY SAVER MODE

In this mode, the machine will operate in a low power mode during off hours to save energy. The display
backlight will be turned off, and the display message will toggle between "Energy Saver/Mode Enabled"
and "Change to Normal/Mode to Clear". The dispense buttons are disabled so that no beverage dispensing
is allowed. The tank refill and powder (soluble) tank heater are disabled. The espresso tank temperature
setting is reduced to 130ºF (54ºC).
To enable the Energy Saver mode:
1. In PROGRAM mode, press the LARGE cup button (button "A"), to navigate to the "LOCKS/DISABLES" menu.
2. Press the button under "YES" (button "B") and then the LARGE cup size, (button "A"), until the screen
displays "ENERGY SAVER?".
3. In the default menu, "NO" will be flashing. Press the button under "YES" to enable the Energy Saver mode.
4. When "YES" is flashing on the display, press the button under "EXIT" to return to the main screen.
5. Place the NORMAL/PROGRAM/RINSE switch to the NORMAL position.
To place the unit in the ENERGY SAVER mode, open the door, and place the NORMAL/PROGRAM/RINSE
switch in the RINSE position. After ten minutes with the switch in the RINSE position, the ENERGY SAVER
mode will become active. If a rinse cycle has taken place, and the switch is left in the RINSE position, the
ENERGY SAVER mode will become active ten minutes after the rinse cycle was completed. To exit the
ENERGY SAVER mode, return the NORMAL/PROGRAM/RINSE switch to the NORMAL position.
OPERATING CONTROLS AND INTERFACE
1
5
9 10
Figure 2
16
SELECT LANGUAGE
(-) ENGLISH (+)
1. SELECT SIZE
Use to
Use to
Scroll
Scroll
3. Use the (-) or (+) buttons to
scroll through the available
languages.
4. Press the button
to accept the new
selection and exit to the
programming menu.