Remove Housing Cover; Remove Rubber Foot - Fellowes Proteus A3/125 Technical & Service Manual

Remove Housing Cover

1
Remove the 4 screws that hold the housing cover to the
base .
2
Carefully lift and turn the housing cover on its side .
3
Disconnect the cable from the Control Panel PCB .

Remove Rubber Foot

1
Turn the laminator over and place it face-down on a soft
surface to avoid damaging the cover housing
2
Remove the screw in the center of the rubber foot .
3
Replace foot and secure it with the screw .
Proteus A3/125 Technical Service Manual
DO THIS FIRST
Unplug the Laminator
TOOLS
Phillips screwdriver
TOOLS
Phillips screwdriver
Revised 09 .15 .11
7