Remove/Replace Cold Roller (Gray) - Fellowes Proteus A3/125 Technical & Service Manual

7
Replace the upper blue Roller .
Note: Make sure the PVC gear is on the left end (away
from the motor) and that the flat side of the Roller bushings
is facing up.
8
Replace the upper red Roller .
9
Replace the Side Panel Covers and secure with
2 screws each .
Note: Make sure the Rollers are level. The Panel Covers
are spring loaded and can push the Rollers out of
alignment.

Remove/Replace Cold Roller (Gray)

Caution: The Cold Rollers (Gray) must be in the rear
position . If the gray Cold Rollers are in the wrong
position, the system will burn and be damaged .
1
Remove the 2 screws each from the right and left Roller
Press Side Panel Covers .
2
Carefully remove Side Panel Covers .
Note: The Covers are spring loaded.
3
Remove the upper red Hot Roller up and out .
4
Lift the upper gray Cold Roller up and out, and then lift
the lower gray Roller .
5
Remove the E-clip on the ends of each gray Roller .
Note: The upper gray Roller has 2 bushings and 1 PVC
gear. The lower gray Roller has 2 bushings, 1 metal gear,
and 1 PVC gear.
Proteus A3/125 Technical Service Manual
DO THIS FIRST
Remove Housing Cover
TOOLS
Phillips screwdriver
E-clip pliers
Revised 09 .15 .11
13