1x3 displayport 1.2 to hdmi mst hub/splitter with pigtail cable (4 pages)
Summary of Contents for GoMax Electronics SP-5018KP
Page 1
However, li ike all elect tronic equip pments, the P should be e used with care. Pleas se read and SP-5018KP 1x9 HDMI over Single CAT5 Splitter follow the safety instr ructions to protect you urself from possible in njury and to...
HDMI Deep Color & full 3D (CV-715s). The SP-5018KP has a local HDMI output for easy monitoring or cascading to another HDMI splitter. With the built in equalization, the input HDMI cable can be extended up to 20 meters long under...
HDMI INPUT: Connect to one HDMI source device HDMI OUTPUT: Connect to a HDMI display for local monitoring or cascade to another HDMI splitter such as SP-5014, SP-5018KP or SP-5028 MODE: 0 = [Video] –2D / Full-HD 24bit 1080p@60 [Audio] – up to 7.1ch surround soundt 1 = [Video] –2D / Full-HD 24bit 1080p@60 [Audio] –...
PIN DEFINITION NOTICE HDMI 1. If the DVI or HDMI device requires the EDID information, please use EDID Reader/Writer to retrieve and provide DVI or HDMI display EDID information. 2. All HDMI over CAT5 transmission distances are measured using Belden 1583A CAT5e 125MHz UTP cable and ASTRODESIGN Video Signal Generator VG-859C.
SELLER will NOT be liable for direct, indirect, incidental, special, or consequential damages resulting from any defect or omission in this manual, even if advised of the possibility of such damages. Also, the technical information contained herein regarding the SP-5018KP features and specifications is subject to change without further notice.
Need help?
Do you have a question about the SP-5018KP and is the answer not in the manual?
Questions and answers