Casio GZE-1 User Manual page 16

. To charge using a USB connection to a computer
Charging time: Approximately 2 hours 55 minutes
USB connection lets you charge the battery while it is loaded in the camera.
While the camera is turned off, connect in the sequence shown below (
• If the camera is on, hold down the [POWER] button for about two seconds to turn it
off before connecting it to your computer.
IMPORTANT!
• The first time you connect the camera to your computer with the USB cable, an
error message may appear on your computer. If this happens, disconnect and then
reconnect the USB cable.
• A battery that has not been used for a long time, certain types of computers, and
connection conditions can cause charging to take longer than normal. These
conditions may also cause the [POWER] lamp to flash red. If this happens, refer to
page 84.
• You cannot use the camera to shoot images while it is being charged over a
computer USB connection. If you want to shoot with the camera, disconnect the
USB cable.
• If you turn on the camera while charging over a USB connection to a computer is in
progress, the camera will establish a USB connection with the computer. Though
charging normally should continue at this time, certain types of computers or
connection environments may stop charging if supply power is low. This will be
indicated by the camera's [POWER] lamp lighting green.
• Charging is not performed while the connected computer is in the hibernate mode.
Position the small (micro USB) connector as shown in the
illustration, plug it in.
[USB] port
USB port
Micro USB cable
(included with camera)
16
, ).
 
Computer
(power turned on)
USB
Quick Start Basics