Exhaust Hose Installation; Choosing The Right Location; Energy Rating Information - Midea MAP12S1TBL Owner's Manual & Installation Manual

Exhaust hose installation

The exhaust hose and adaptor must be installed or removed in accordance with the usage mode. For
COOL,HEAT(heat pump type) or AUTO mode must be installed exhaust hose. For FAN, DRY or HEAT
(electrical heat type) mode must be removed exhaust hose.
应品质要
求，增加

Choosing The Right Location

出风口与
障碍物距
离50cm(工
程师提供
的数据)。
Recommend Installation

Energy Rating Information

The energy rating and noise information for this unit is based on the standard installation using an un-extended
exhaust duct (Diameter:150mm, Length:1.5m) without window slider adaptor or wall exhaust adaptor A.
The unit with 3 meters extended exhaust duct is running by using 2 exhaust ducts(Diameter:150mm, Length:1.5m
+ Diameter: 130mm, Length: 1.5m) .The Energy rating and noise information for unit with 3 meters extended
exhaust duct is not assessed.(For some models)
NOTE：
We recommend that operating the unit at room temperature below
meters extended exhaust duct would not work at room temperature above
such as the lower air intake be blocked for 50%.
How to Stay Cool with a New Portable Air Conditioner(For the models comply with the
requirements of Department Of Energy in US)
Because of a new federal test procedure for Portable Air Conditioners, you may notice that the
cooling capacity claims on portable air conditioner packaging are significantly lower than that of
models produced prior to 2017. This is due to changes in the test procedure, not to the portable
air conditioners themselves.
 
Page 12
Your installation location should meet the following requirements:
-Make sure that you install your unit on an even surface to minimize noise and
vibration.
-The unit must be installed near a grounded plug, and the Collection Tray Drain
(found on the back of the unit) must be accessible.
-The unit should be located at least 30cm (12") from the nearest wall to ensure
proper air conditioning. The horizontal louver blade should be at least 50cm
(19.7") away from obstacles.
-DO NOT cover the Intakes, Outlets or Remote Signal Receptor of the unit, as this
could cause damage to the unit.
选配了加长软管的产品，认证要求增加加长软管的测试说明并且要放在产品整机安装图后
35°C . Since there is a risk that the unit with 3
35°C under some extreme conditions,
原DOE机型中单页的DOE说明，
现整合到整机说明书中。