Further Information; Troubleshooting - Acclaim Lighting aria Dyna Accent User Manual

FURTHER INFORMATION

TROUBLESHOOTING

NO LIGHT OUTPUT IS VISIBLE WHEN EXPECTED.
• Check that power is correctly applied to the fixture and that there is no damage to the
power input cord.
• Use the menu to perform an emitter test.
• Use an RDM tool to perform an emitter test.
• Use the menu to check the internal temperature of the fixture.
• If external DMX control is being used, check that the DMX address set within the fixture
matches that being output by the controlling source device.
• If external DMX control is being used, check the DMX output near to the source to
confirm a valid signal is being originated. When a valid DMX input is attached to the Dyna
Accent fixture, the user display will show the configured DMX address.
• If external DMX control is being used, check that the DMX + (hot) and DMX - (cold) lines
have not been crossed.
• If the Internal Color/Output Mode is being used, check that the static color or white-only
output has been correctly programmed (see page 23) and that the appropriate solo
mode is selected (see page 27).
• If Aria wireless DMX control is being used, check that the fixture is set to the same wireless
channel as the transmitter (the wireless channel is independent of the DMX address). Try
changing the transmitter and receiving fixture(s) to different (but equal) wireless channels
to check for clear space in the radio spectrum from interference by other devices, such as
WiFi.
DIMMING AND/OR CHASE CHANGES ARE JERKY WHEN USING ARIA.
• Check for WiFi sources near to the transmitter or receiver devices. Try changing the
transmitter and receiving fixture(s) to different (but equal) wireless channels to check for
clear space, from interference by other devices, in the radio spectrum.
www.acclaimlighting.com
33