JAC HFC4181KR1 Owner's Manual page 80

OWNER ' S MANUAL
JAC HEAVY DUTY TRUCK
2. Remove the rubber cap from the air bleeder of the clutch booster, mount
one end of a transparent vinyl hose, and put the other end in a bowl contain鄄
ing brake fluid.
3. Depress the clutch pedal several times. After the stroke has settled, keep
the pedal depressed.
Let the assistant loosen the air bleeder to
brake fluid. Let him tighten the air bleeder immediately after air has been dis鄄
charged.
NOTE:
If the brake fluid is discharged from the air bleeder, the stroke of the pedal will
change. Tighten the air bleeder immediately after the pedal has touched the
stopper.
4. After the air bleeder has been tightened, release the pedal.
5. Repeat steps 3 and 4 until there are no more air bubbles in the brake fluid
that runs out from the air bleeder. As a final step, tighten the air bleer firmly
and install the rubber cap.
6. Check the fluid level in the fluid reservoir tank and add brake fluid up to the
"H" level. Depress the clutch pedal to check for fluid leaks.
152
discharge the air along with the
CHECKING THE BRAKES
CAUTION:
Because brakes are essential to the safe operation of the car, it is suggested
that they be checked and inspected by your JAC dealer. The brakes should
be checked and inspected for wear at those intervals specified in the vehicle
maintenance schedule in Section 6-3.
Checking the Brake Fluid Level
WARNING:
Use caution when handling brake fluid. It can damage your vision if it get into
your eyes. It will also damage your vehicles paint if spilled on it and not re鄄
moved immediately.
To Check the Fluid Level (If installed)
The fluid level in the brake fluid reservoir should be checked periodically. The
level should be between the "L' and "H" marks on the side of the reservoir. If
the level is at or below the "L" mark, carefully add fluid to bring it up to "H". Do
not overfill.
153