JAC HFC4181KR1 Owner's Manual page 44

OWNER ' S MANUAL
JAC HEAVY DUTY TRUCK
SELECT LEVER
Manual Transmission
Your Manual Transmission vehicle has a fully synchro-meshed, 8-forward and 1-reverse or 5-forward and 1-reverse
speed transmission controlled by a gear shift, lever located on the floor. This shift pattern is shown on the knob.
When shifting the gear shift lever, fully depress the clutch pedal, then release the pedal slowly. Make full use of the gear
position.
On 5-speed transmission, shifting to neutral is necessary before Reverse (R).
CAUTION:
Shift to the reverse position only when the vehicle is completely stopped.
●
● Do not rest your foot on the clutch while driving, because it will cause needless wear.
● Do not hold your vehicle with the engine when stopped on the upgrade. Use the parking brake.
80
Multi-speed transmission
Shifting
Operate the gearshift lever by the same procedures as for a general vehicle.
Shifting of only splitter between High and Low
Example: 4L→4H
1. Place the splitter control lever to 'H' or 'L'.
2. Release the accelerator pedal and depress the clutch pedal all the way,
and automatic changeover will be made to High or Low. Check to see that
the or , indicator lamp is ON.
Simultaneous shifting of both gearshift lever and splitter
Example: 4H→5L or 4L←5H
1. Place the splitter control lever to 'H" or "L".
2. Release the accelerator pedal and depress the clutch pedal all the way, and
automatic changeover will be made to High or Low. Check the
cator lamp which will light when the changeover is made.
3. Shift the gearshift lever.
or indi鄄
81