JAC HFC4181KR1 Owner's Manual page 68

OWNER ' S MANUAL
JAC HEAVY DUTY TRUCK
THE POSITION OF REAR WHEEL
NOTE:
Do not place the jack under Rod-Radius.
HOW TO OPERATE THE JACK
To raise
If the jack-up point is high, extend the jack by turning the jack head counter鄄
clockwise. Close the valve 1 by turning it clockwise and then insert the wrench
handle into the socket 2 and move it up and down.
128
To lower
Turn the valve counterclockwise by the wrench handle.
NOTE:
After using, push the jack all the way down and close the valve.
CAUTION:
Do not overload when raising the jack.
TOWING
When using the towing hook, observe the following:
Make sure that the towing angle of hook does not exceed the limits shown in
illustration. Make sure that no load is abruptly placed on the towing hook.
NOTE:
The angles specified in illustration hold good when your vehicle Is towed by a
towing vehicle about the same size.
When your vehicle is towed, pay attention to the following points
● Use strong ropes and fasten the ropes to the hooks in such a way that they
won't be allowed to come off.
129