ABC Design Pramy Luxe Instructions For Use Manual page 9

1. Opening the pushchair
Pull the handle up.
Push the handle back until the hinges lock into place on the left and right.
Caution: Ensure that all the catches are engaged before use.
2. Fitting the wheels
Press the button (1) and insert the rear wheel in the slot (2) until it engages.
To remove the wheels, press the button (1) to release the wheels.
The wheels can then be removed from the axle.
Mount the front wheels by sliding the wheel assemblies onto the prongs until they click into place.
To remove the wheel assemblies, press the button underneath the blocks and remove the assemblies.
3. Wheel locking and swivel settings
Push the lever downwards to lock the wheels.
Push the lever upwards for swivel position.
4. Attaching and removing the hood
Lower the hood down onto the attachment
To remove the hood, press the buttons in on both sides of the hood.
5. Fitting and removing the guard rail
Fit the guard rail by inserting it in the plastic mounts on both sides.
To remove the guard rail from the pushchair, press in the buttons on both sides and pull the guard rail off
away from the pushchair.
To adjust the height of the guard rail, press and hold down the buttons on each side and push the bar up
or down.
6. Fastening the harness
a.
To fasten the harness, bring the top two plastic catches together and interlock them.
b.
Then insert the interlocked catches into the bottom part of the fastening.
Adjust the harness to a setting where the baby is held in the correct position.
7. Unfastening the harness
To open the harness, press the button on the side.
CAUTION: Always use the shoulder harness and lap belt together.
EN - 06