Pressure Drop; Care And Maintenance - pro.point 8844193 Manual

8844193
5. Pass the sander back and forth in wide, overlapping areas, taking care
to keep the sander moving around at all times. Let the tool do the work.
The weight of the machine is normally sufficient for efficient sanding.
6. Remove the sander from the workpiece before stopping the tool.
7. Remove and empty the dust bag when partially filled. Do not wait
until the bag is full as a full bag will impede the exhaust's airflow.
Empty and store the bag and hose after completing the task.
8. When finished with the tool, turn off the air compressor, disconnect
the air hose and discharge any residual air remaining in the tool.
Put the tool away in a safe storage area.

PRESSURE DROP

Apply the air consumption and pressure rate numbers to the tool's air
inlet, not the compressor's outlet. Calculate the pressure drop for your
air supply set-up and increase the compressor outlet pressure to
compensate. Make sure you do not exceed the maximum pressure for
any part of your air supply system.
Installing a pressure gauge at the tool inlet is the best way to measure
the air pressure and adjust the compressor's output.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2. Inspect the tool fittings, alignment and hoses periodically. Have
damaged or worn components repaired or replaced by an authorized
technician. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool clean, dry and free from oil/grease at all times.
6. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
10
6 in. Random Orbital Air Palm Sander
For technical questions call 1-800-665-8685
V1.0