Table of Contents
Advertisement
11 SERVICE WORK ON THE CHASSIS
11.42
11.43
74
Checking the rubber grip
401197-01
V02072-10
Adjusting the basic position of the clutch lever
F00009-11
Finishing work
–
Install the fuel tank.
(
–
Install the right side cover. (
–
Mount the seat. (
p. 60)
–
Install the air filter box cover. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
»
If a rubber grip is damaged or worn
–
Change the rubber grip.
–
1
Check that screw
is firmly seated.
Guideline
Screw, fixed
M4
grip
A
Diamond
must be located at the top.
–
Adjust the basic position of the clutch lever to your hand size
by turning adjusting screw
Info
When the adjusting screw is turned counterclockwise,
the clutch lever moves away from the handlebar.
When the adjusting screw is turned clockwise, the
clutch lever moves closer to the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not
apply any force.
Do not make any adjustments while riding.
p. 66)
p. 65)
p. 60)
5 Nm (3.7 lbf ft)
®
Loctite
1
.
243™
Advertisement
Table of Contents
