Service Work On The Engine 16; Checking The Gear Oil Level; Changing The Gear Oil - Husqvarna TC 250 2022 Owner's Manual

16.1

Checking the gear oil level

Info
The gear oil level must be checked when the engine is cold.
16.2

Changing the gear oil

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Drain the gear oil while the engine is at operating temperature.

SERVICE WORK ON THE ENGINE 16

Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Remove gear oil level monitoring screw
–
Check the gear oil level.
A small quantity of gear oil must run out of the drilled hole.
» If no gear oil runs out:
–
Add the gear oil.
–
Mount and tighten the gear oil level monitoring screw.
Guideline
K01299-10
Screw, gear oil level
monitoring
Preparatory work
–
Park the motorcycle on a level surface.
–
Position an appropriate container under the engine.
1
.
( p. 112)
M6 8 Nm (5.9 lbf ft)
111