Table of Contents
Advertisement
16 SERVICE WORK ON THE ENGINE
16.3
112
K01300-10
Adding the gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Gear oil must only be topped up when the engine is cold.
K01299-10
Main work
–
Remove gear oil drain plug
–
2
Remove filler plug
with the O-ring.
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug
and a new seal ring.
Guideline
Gear oil drain plug
with magnet
–
Fill up with gear oil.
Gear oil
–
Mount and tighten filler plug
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check for leaks.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Park the motorcycle on a level surface.
Main work
–
Remove gear oil level monitoring screw
1
with magnet.
1
with the magnet
M12x1.5
20 Nm (14.8 lbf ft)
0.8 l (0.8 qt.)
Engine oil (15W/50)
(
p. 129)
2
with the O-ring.
p. 111)
1
.
Advertisement
Table of Contents
