11.27
Removing the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
11.28
Installing the main silencer
11.29
Changing the glass fiber yarn filling of the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the rock wool escape into the air, and the main silencer "burns out".
Not only is the noise level higher, but the performance characteristics change.
SERVICE WORK ON THE CHASSIS 11
–
Remove screws
–
Pull off the main silencer from the manifold at sleeve
K01257-10
–
Position the main silencer in sleeve
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
K01258-10
Preparatory work
–
Remove the main silencer. (
1
with the washers.
1
.
2
with the washers.
M6
10 Nm (7.4 lbf ft)
p. 63)
2
.
63