Eagle TriFinder 2 Installation And Operation Instructions Manual page 31

100 percent, but the unit will limit your minimum setting. This prevents
you from turning sensitivity down too low to allow automatic bottom
tracking. When you change the setting with auto turned on, the unit will
continue to track the bottom and make minor adjustments to the sensi-
tivity level, with a bias toward the setting you selected.
Adjusting sensitivity in Manual Sensitivity Mode is similar to driving a
car without cruise control — you have complete manual control of the
car's speed. In your unit, manual mode allows you to set sensitivity at
100 percent (maximum) or zero percent (minimum.) Depending on wa-
ter and bottom conditions, the bottom signal may completely disappear
from the screen when you reduce sensitivity to about 20 percent or less!
Try adjusting sensitivity in both auto and manual modes to see how
they work.
Sensitivity menu screens. Left, automatic or manual menu.
Right, Sensitivity Adjustment menu.
To adjust sensitivity:
Press until the menu appears. Press
MENU S A UP
ENSITIVITY DJUSTMENT
to increase the sensitivity, to decrease it. When
ARROW DOWN ARROW
it's set at the desired level, press to clear the menu.
PWR
The sensitivity percentage in use shows in this menu. As you change
the setting, echoes scrolling onto the screen will show the effects of the
change. If you reach the maximum or minimum sensitivity level, a tone
sounds alerting you to the limits.
27