Digital Data Size For Depth, Temperature, Speed And Distance Log - Eagle TriFinder 2 Installation And Operation Instructions Manual

detail seen on the sonar chart. Try this command only if you are in deep
water, traveling at high speed, and notice a reduction in detail on the
sonar chart. When Limit Search is turned on, the digital sonar will
limit its search for the bottom to the depth range you have set for the
sonar chart.
NOTE:
Turning Limit Search on can cause the digital sonar to lose the bot-
tom in some situations. The digital depth will flash if that occurs.
The sonar chart must be in manual depth range mode to use the Limit
Search command. To switch from auto depth range to manual, press
until the
MENU
desired range. When you're finished, press
the display.
Next, press
MENU DOWN
press
UP ARROW
menu appears. Press
L S
IMIT EARCH
to clear the menu.
PWR
To turn Limit Search off, repeat the above steps but press the Down
Arrow to select "Off." Also remember to switch the depth range setting
back to automatic. This will restore the digital sonar's ability to auto-
matically track the bottom.
DIGITAL DATA SIZE FOR DEPTH, TEMPERATURE, SPEED,
and DISTANCE LOG
The size of the digital numbers for the depth, temperature, speed and
distance log can individually be changed to any one of three sizes. The
digital displays can also be turned off or on.
menu appears. Use the arrow keys to select the
R
ANGE
until the
to enter the list of Chart Setup commands, where the
Limit Search menu.
PWR
C S
HART ETUP
to turn it on and press
UP ARROW
44
to clear the menu from
menu appears, then