Related Manuals for Wren Kitchens BASE UNIT 150
Summary of Contents for Wren Kitchens BASE UNIT 150
- Page 1 BASE UNIT 150-200 1 Door Assembly Guide For Internal Use: FI.WR.INS.019_WKIN00100_BASE_150-200_1Dr_Rev4.indd...
- Page 2 BASE UNIT BEFORE YOU START 150-200 1 Door INSTALLATION SHOULD BE PERFORMED BY A Assembly Guide COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Panel A Panel B Shelf Legs Frontal Panel C x1 Back Panel x2 End Panel (Packed separately) x2 Fixed Panel Hinge Mounting Plate...
- Page 3 BASE UNIT 150 -200 1 Door Step 1. Assembly Guide Seat dowel (F) into holes in both end panels (B) as shown. Seat (G) cam dowel Step 2. into hole as shown. Seat cam dowel (G) into holes in both end panels (B) as shown.
- Page 4 BASE UNIT 150-200 1 Door Assembly Guide Step 5. Slide back panel (A) into groove of end panels (B). Once back panel (A) is in position, ensure the panel is flush & square with bottom of end panels (B). Step 6. Hand tighten all cam locks (H), this will expand cam dowels (G) and tighten the unit together.
- Page 5 BASE UNIT 150 -200 1 Door Assembly Guide Step 8. Secure each of the legs into place with 2 x 15mm screws (L) per leg. Ensure legs are rotated as shown so that part of it is supporting the end panels (B). Front legs should have flat edge to the front.
- Page 6 BASE UNIT 150-200 1 Door from top Assembly Guide 94mm 126mm Hinge Plates Step 11. Attach hinge mounting plate onto both End Panel or panels, (B) as shown, using Screws which are already positioned within the Hinge Plates. Hinge side or sides to be mounted in accordance to 126mm customer kitchen plan.
- Page 7 BASE UNIT 150 -200 1 Door Assembly Guide Step 12. Insert hinge in top & bottom holes as shown below. Step 13. Secure hinges by tightening 2 x screws with hinge dowels attached. These are already positioned within the hinges. Step 14.