Water Softener; Water Hardness; Setting The Water Hardness Level - Miele PG 8581 Operating Instructions Manual

Water softener

26

Water hardness

In order to achieve good cleaning results, the machine needs to
operate with soft (low in calcium) water. Hard water results in the
build-up of calcium deposits on the load and the machine.
Mains water with a water hardness of .7 mmol/l (4 gr/gal) must be
softened. This occurs automatically in the built-in water softener.
The water softener must be set to the exact hardness of the mains
water (see "Water softener/Setting the water hardness").
Your local water authority can give you information about the exact
water hardness in your area.
It is useful to know your water hardness so that you can provide the
service technician with this information in the event of any
subsequent service calls. For this reason, record the hardness of the
mains water here:
________________________mmol/l or gr/gal
The water softener must be reactivated at regular intervals. This
requires special reactivation salt (see "Water softener/Filling the salt
reservoir"). Reactivation is carried out automatically during a program
sequence.
If the hardness level of your water is constantly less than .7 mmol/l
(= 4 gr/gal), salt is not required for the water softener. The water
hardness level must, however, still be set.

Setting the water hardness level

Water hardness can be set between 0 - 70 gr/gal.
Open the menu as follows:

Button 
 Additional settings
Water hardness

The bottom line of the display shows the possible input range. Water
hardness input values can be found in the chart on the next page.
Where the water hardness fluctuates, e.g. between 8 - 17 gr/gal,
always program the machine to the higher value, 17 gr/gal in this
example.
Set the water hardness level using the arrow buttons ( = higher

and  = lower).
Press OK to save the setting.

Water hardness
19
gr/gal
(0 - 70 gr/gal )