Interface Connection - Elo TouchSystems 2242L User Manual

Interface Connection

Connector Panel on Rear Side of Monitor
1
1. Power cable
2. Power button
3. OSD control box connector
4. USB cable
To connect the touchmonitor to the computer:
1 Connect the power cable to the rear panel of the monitor and the
other end to the power outlet.
2 Connect the USB cable to the rear panel of the monitor.
Connect the other end to your computer.
3 Connect the VGA video cable and/or the DVI-D cable to the rear
panel of the monitor. Tighten by turning the two thumb screws
clockwise to ensure proper grounding. Connect the other end to
your computer.
4 Connect the OSD control box to the monitor.
5 Press the power button on the rear panel to turn the monitor on.
6 Cancel any attemps by your Operating System to install a touch
driver for the touchmonitor.
2 3 4
5. DVI-D video cable
6. Analog VGA video cable
Elo TouchSystems 2242L User Guide
5 6
8