Circumventing The Air Theader - Bernina L860 User Manual

Threading
> Pull the auyiliary thread ends until the looper thread comes out of the looper eye.
> Remove the auxiliary thread.
> Place the looper thread under the presser foot to the rear left.

Circumventing the air theader

Some thick or decorative threads cannot be threaded through the air threader nozzles or don't provide
optimal stitch formations when these threads are threaded through the air threader pipes.
Alternatively, such threads may be threaded through the air threader circumvention. This reduces the friction
in the air threader pipes and results in a lower thread tension.
Prerequisite:
• The looper thread is threaded and can serve as auxiliary thread.
> Open the threader cover and the looper cover.
> Set the air threader connector to «0».
> Using the tweezers pull the looper thread out of the air threader pipe exit creating a thread loop.
> Cut the loop with scissors.
> Replace the looper thread on the thread stand with the desired special thread.
90