Related Manuals for Alloy ESM-24T02M
Summary of Contents for Alloy ESM-24T02M
- Page 1 ESM-24T02M EtherGuard Managed Switch by Alloy Quick Installation Guide V 1.0 1 of 5...
- Page 2 Switch in the rack. Power On the Switch: The ESM-24T02M Switch has a universal power supply (90 ~ 260V AC, 50 ~ 60Hz power source). The AC power cord connector is located at the rear of the unit and the On/Off switch is next to the connector.
- Page 3 LED indicators information Color Status Solid Blinking Power Green Power is applied to this device DIAG Green Self diagnostic successful Performing self diagnostic (after Power On) FAN1 Left cooling fan failed Cooling Right cooling fan failed FAN2 Fans LINK/ACT Green 10Mbps Ethernet connection speed TX/RX activity or Collision (1 ~24 port) Green 100Mbps Fast Ethernet connection...
- Page 4 Setup the COM port properties by using the information below and click “OK”. Bits Rate per Second = 9600 Data Bits = 8 Parity = None Stop Bit = 1 Flow Control = None Connect the included serial cable from the computer’s COM port to the Switch’s console port.
- Page 5 How to Modify Switch’s IP address via Out-of-Band method 1. Login to the console (note: default User Name: admin, Password: admin). 2. Use “Tab” key to select (highlight) “Switch Static Configuration” and hit “Enter”. 3. Use “Tab” key to select “Administration Configuration” and hit “Enter”. 4.
Need help?
Do you have a question about the ESM-24T02M and is the answer not in the manual?
Questions and answers