Related Manuals for Alloy SmartHome Fusion 3
Summary of Contents for Alloy SmartHome Fusion 3
-
Page 1: Table Of Contents
| Before Installation Required Tools Network Requirements Unboxing Package Contents | Installation Locating the Serial Number Removing the Wall Plate Installation Notes Mounting the Fusion (gen3) Alloy SmartHome Fusion (gen3) Initial Boot Installer Menu Navigation Actions Installation Workflow | Frequently Asked Questions/Troubleshooting... -
Page 2: Alloy Smarthome Fusion (Gen3)
If firewalled, ports UDP port ○ 123 and TCP port 443 allowed Unboxing Package Contents ● Alloy SmartHome Fusion (gen3) with attached wall plate ● 4 x Drywall Anchors (Self Tapping) ● 4 x Drywall Anchors (Standard) ● 4 x Drywall Screws... -
Page 3: Pre-Installation Notes
Manager or Alloy Install. Removing the Wall Plate To separate the Alloy Fusion (gen3) body from the wall plate, place the index finger inside the cable ingress location and place the thumb where the small slotted opening is at the bottom. -
Page 4: Mounting The Fusion (Gen3)
Mounting the Fusion (gen3) Before mounting the Fusion (gen3), Remove the existing thermostat and inspect the wiring. Ensure each wire is free of cuts or breaks in the shielding. Ensure only ¼” to ⅜” of wire is exposed. Failure to do so may result in HVAC system and/or device damage. -
Page 5: Alloy Smarthome Fusion (Gen3) Initial Boot
Fusion as shown. Alloy SmartHome Fusion (gen3) Initial Boot When the Alloy Fusion (gen3) is booted for the first time, it will start in an installer workflow so the device can be configured for the proper HVAC system configuration. Installer Menu... -
Page 6: Frequently Asked Questions/Troubleshooting
| Frequently Asked Questions/Troubleshooting Q: How can I find the Serial Number of my Fusion (gen3)? A: The serial number of your Fusion (gen3) is located on the box, wall backplate and the back of the front plates of every model. It can also be viewed in the Installer Mode Menu. Q: How can I find the Ethernet or Wifi... - Page 7 Q: Can I still control all my devices from the SmartRent app? A: Yes! All devices are still controllable from within the mobile app or web portal. Q: Can I create a thermostat schedule directly from the Fusion (gen3) screen? A: No, today schedules can only be created and implemented from the mobile app.
- Page 8 • To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and Quad-Core Cortex-A53 ARM CPU ENVIRONMENTAL EN 301 489-52 V1.2.1 Alloy Fusion v3 operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna. EN 55032:2015+A11:2020 1.1 GHz CPU...
- Page 9 RESULTING FROM THE USE OF OR INABILITY TO USE We, Alloy Home, LLC, 8665 E. Hartford Drive, Suite 200, Scottsdale, AZ 85255, declare that the product Alloy Fusion • Alloy Fusion v3 demo power adapter is damaged and you suspect it needs to be serviced.
Need help?
Do you have a question about the SmartHome Fusion 3 and is the answer not in the manual?
Questions and answers