3 Basic Operations
This chapter describes the basic operations of the X-618 Config software.
Running the Software
Note:
Make sure X-SMART software and the X-618 Config software are not running at the same time.
If the X-SMART software is running, the X-618 Contig software cannot be run.
The steps for running the software are as follows:
1. Click Start at the lower left of your computer desktop, and select Program
618 Config.
2. Select the menu commands Tools
displayed. The user can select the appropriate language. Click OK. The main window which is
shown in English is displayed as shown in Figure 3.
Figure 3 X-618 Config Software Initial Window
Exiting the Software
Select the menu commands Project
dialogue displays. Click Yes in this prompt dialogue to exit the software.
Select Language, the Select Language window is
Exit or click the "X" icon
X-618 Config
on the upper right
corner, a prompt
X-
8