Device Settings - Honeywell X-618 Commissioning Manual

Device Settings

The basic function parameters for the NRI can be set under this tab, such as properties and
supervision.
1． Properties
"Properties" is used to set the requisite parameters for the NRI, including Base Setting, Network
Setting, Date & Time, Audio Source Setting and Device Status Output, as shown below:

Base Setting
Base Setting includes the Device ID, Device Name, Device Type, Storage and Master. Device ID is
the only device identification in the system, which is in the range of 7000~8000. Enter a name to
mark the device for the convenience of the user's identification. Storage is used to select the audio
files' storage position. The built-in 500MB flash (Max. 96 minutes) and 4GB SD card are selectable.
The master setting is used to set the current NRI as a master. If the NRI is set to be a master, the
fault status of all the equipment in the same device group will be sent to the master NRI. When the
system has any fault, the NRI will send out an acousto-optic warning and the fault relay will open to
indicate a fault on the system.
Only one NRI can be set as a master in each device group.

Network Setting
Used to set the NRI network parameters. Old IP is the IP address before setting, and New IP is the
IP address after setting. For updating the network parameters of the system devices, it should be
connected to computer whose IP should be in the same segment with the old IP of NRI. Click the
Update button for setting the IP of NRI, the two IP address would be the same after updating
successfully. The default IP address is 192.168.2.200. If the upload of settings to the devices failed,
or if the specified IP address has been forgotten, the default IP address can be obtained by
pressing the number button to reset the IP address.
Note: The network parameter is excluded in the configuration files. If there is a problem with the
network configuration, the only way to correct it is to update the network. While operating, please
make sure the device is connected to the network and the network settings are correct.
45