Viewing The Firmware Version; The Tool Library - Harbor Freight Tools ZURICH OBD2 Owner's Manual

Additional Functions
VIEWING FIRMWARE VERSION - TOOL LIBRARY
VIEWING THE FIRMWARE VERSION - THE TOOL LIBRARY
4. Start and warm the engine to normal operating temperature. Turn on
the headlights. Press ENTER
An "instructional" message shows.
5. Press the accelerator pedal to raise engine speed to 2000 RPM,
and maintain the engine speed.
When engine speed is within the required range, the alternator
test begins. A progress screen shows.
When the "countdown" timer expires, an "instructional" message
shows.
6. Turn the vehicle's headlights off, and
return the engine to idle speed.
A "One moment please..." message
displays while the test results are
retrieved.
7. When the alternator check is complete,
a results screen shows charging system
voltage and indicates whether or not the
charging system is within acceptable
limits. The SYSTEM STATUS LEDs
provide a PASS/FAIL indication, as
follows:
Green = System within limits
Yellow = Over charging or under
charging
Red = Excessive over charging or
under charging
If the alternator voltage is less than 9 V, the red, yellow and
green SYSTEM STATUS LEDs will flash on and off.
8. Press M to return to the Main Menu.

VIEWING THE FIRMWARE VERSION

1. Select Firmware Version in the Main
Menu, then press ENTER
The Firmware Version screen displays.
The screen shows the scan tool's
current firmware version, bootloader
version and database version.
2. Press M to return to the Main Menu.

THE TOOL LIBRARY

The Tool Library contains valuable reference information for the Scan
Tool. The following functions are available:
28
28
For technical questions, please call 1-888-866-5797
to continue.
.