Harbor Freight Tools ZURICH OBD2 Owner's Manual page 13

VIEWING OEM ENHANCED DTCs (except Ford/Mazda)
When (make) OEM Enhanced is chosen from the System Menu, the
Scan Tool retrieves OEM enhanced DTCs from the vehicle's computer.
1. A "One moment please" message displays while the Scan Tool
retrieves the selected DTCs.
If the Scan Tool fails to link to the vehicle's computer, a
"Communication Error" message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press LINK
If the Scan Tool cannot link to the vehicle's computer after three
attempts, the message "Contact Technical Support" displays.
- Press SYSTEM MENU
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
2. Refer to DISPLAY FUNCTIONS on page 3 for a description of LCD
display elements.
If no codes are present, the message "No OEM Enhanced
DTC's are presently stored in the vehicle's computer" shows.
Press SYSTEM MENU
3. If more than one code was retrieved press DTC/FF to display
additional codes one at a time.
Whenever the Scroll function is used, the Scan Tool's
communication link with the vehicle's computer disconnects. To
re-establish communication, press LINK
4. When the last retrieved DTC has been displayed and DTC/FF is
pressed, the Scan Tool returns to the "Priority" code.
For technical questions, please call 1-888-866-5797
VIEWING OEM ENHANCEED DTCs
VIEWING OEM ENHANCED DTCs (except Ford/Mazda)
to continue.
If the definition for the cur-
rently displayed code is not
available, an advisory mes-
sage shows.
I/M MONITOR STATUS
icons are not displayed
when viewing enhanced
DTCs.
In the case of long code
definitions, a small arrow is shown in the upper/lower
right-hand corner of the code display area to indicate the
presence of additional information.
Using the Scan Tool
to return to the System Menu.
to return to the System Menu.
again.
11
11