Harbor Freight Tools ZURICH OBD2 Owner's Manual page 25

OBD Monitor Test
The OBD Monitor Test function retrieves and displays test results for
emission-related powertrain components and systems that are not
continuously monitored. The tests available are determined by the
vehicle manufacturer.
The diagnostic tool does not perform the OBD monitor test, but
retrieves results from the most recently performed tests from
the on-board computer's memory. You may retrieve OBD
monitor test results for only one test at any given time.
1. From the System Test menu, select
OBD Monitor Test, then press ENTER
.
2. A "One moment please. . ." message
displays, followed by the Select Test
screen. (Refer to the vehicle's service
repair manual for information related to
non-continuous tests.)
If OBD monitor test data is not presently stored in the vehicle's
computer, an advisory message displays. Press M to return to
the Main Menu.
If OBD monitor tests are not supported by the vehicle under test,
an advisory message displays. Press M to return to the Main
Menu.
3. Select the desired test, then press
ENTER
The display
information:
Test ID number
Module ID number
Component ID number
Min or Max test limit (Only one test limit, either Min or Max , is
shown for any given test.)
Test Value and status
Status is calculated by the diagnostic tool by comparing the
Test Value against the displayed test limit (either Min or Max ).
Status is shown as either Low, High or OK.
4. When you have finished viewing the retrieved test data, select Back
on the Select Test screen, then press ENTER
System Test menu; or, press M to return to the Main Menu.
EVAP Test
The EVAP Test function lets you initiate a leak test for the vehicle's
EVAP system.
For technical questions, please call 1-888-866-5797
to display the test results.
shows the
Additional Functions
SYSTEM TEST MENU
SYSTEM TEST MENU
following
to return to the
23
23