Harbor Freight Tools ZURICH OBD2 Owner's Manual page 15

If the KOEO test was selected, and the vehicle's engine is
running, an advisory message shows.
- Turn the ignition OFF then back ON and press ENTER
try again, or, press SYSTEM MENU
System Menu.
4. If the KOER test was selected, an "instructional" message shows.
Turn the steering wheel to the left, then release.
Press and release the brake pedal.
Cycle the overdrive switch (if equipped).
A "One moment please" message
displays while the test is in progress.
5. Refer to DISPLAY FUNCTIONS on
page 3 for a description of LCD display
elements.
If no codes are present, a "System
Pass" displays. Press any Hotkey.
6. If more than one code was retrieved
press DTC/FF to display additional
codes one at a time.
7. When the last retrieved DTC has been
displayed and DTC/FF is pressed, the
Scan Tool returns to the "Priority" code.
To view additional enhanced DTCs, repeat steps 1 through 6,
above.
To exit the enhanced mode, press SYSTEM MENU
to the System Menu. Select Global OBD, then press ENTER
to return to the Global OBD2 mode.
VIEWING ABS DTCs
Refer to the manufacturer's website for vehicle makes covered.
Reading ABS DTCs
1. When ABS is chosen from the System Menu, a "One moment
please" message displays while the Scan Tool retrieves the selected
DTCs.
For technical questions, please call 1-888-866-5797
I/M MONITOR STATUS
icons are not displayed
when viewing enhanced
DTCs.
In the case of long code definitions, a small arrow is
shown in the upper/ lower right-hand corner of the
code display area to indicate the presence of additional
information.
Using the Scan Tool
VIEWING ABS DTCs
VIEWING ABS DTCs
to return to the
to
to return
13
13