Harbor Freight Tools ZURICH OBD2 Owner's Manual page 14

Using the Scan Tool
VIEWING OEM ENHANCED DTCs
VIEWING OEM ENHANCED DTCs (Ford/Mazda only)
To exit the enhanced mode, press SYSTEM MENU
to the System Menu. Select Global OBD, then press ENTER
to return to the Global OBD2 mode.
VIEWING OEM ENHANCED DTCs (Ford/Mazda only)
Mazda Enhanced DTCs are available for Mazda-branded
Ford vehicles only.
When Ford OEM Enhanced is chosen from
the System Menu, the Ford OEM Enhanced
menu displays. You may view DTCs for
either the "Continuous Memory Test",
"KOEO (Key On Engine Off) Test" or
"KOER (Key On Engine Running) Test."
1. Select the desired option, then press
ENTER
If KOER is selected, an advisory message shows.
- Start and warm the engine to normal operating temperature,
then press ENTER
2. If KOEO or Continuous Memory is selected, an "instructional"
message shows.
Turn the ignition OFF, then back ON. Press ENTER
Proceed to step 3.
3. A "One moment please" message displays while the test is in progress.
If the Scan Tool fails to link to the vehicle's computer, a
"Communication Error" message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press LINK
If the Scan Tool cannot link to the vehicle's computer after three
attempts, the message "Contact Technical Support" displays.
- Press SYSTEM MENU
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
If the KOER test was selected, and the vehicle's engine is not
running, an advisory message shows.
- Start the engine and press ENTER
SYSTEM MENU
12
12
For technical questions, please call 1-888-866-5797
.
. Proceed to step 3.
to continue.
to return to the System Menu.
to return to the System Menu.
to try again, or, press
to return
.