Harbor Freight Tools ZURICH OBD2 Owner's Manual page 16

Using the Scan Tool
VIEWING ABS DTCs
VIEWING ABS DTCs
If ABS functionality is not supported, an advisory message
shows. Press SYSTEM MENU
If the Scan Tool fails to link to the vehicle's computer, a
"Communication Error" message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then turn back ON to reset
the computer.
- Press LINK
If the Scan Tool cannot link to the vehicle's computer after three
attempts, the message "Contact Technical Support" displays.
- Press SYSTEM MENU
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
2. Refer to DISPLAY FUNCTIONS on
page 3 for a description of LCD display
elements.
If the definition for the currently
displayed code is not available, an
advisory message shows.
I/M MONITOR STATUS icons are
not displayed when viewing ABS
DTCs.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information.
If no codes are present, the message "No ABS DTC's are
presently stored in the vehicle's computer" shows. Press
SYSTEM MENU
3. If more than one code was retrieved press DTC/FF, as necessary,
to display additional codes one at a time.
Whenever the Scroll function is used, the Scan Tool's
communication link with the vehicle's computer disconnects. To
re-establish communication, press LINK
4. When the last retrieved DTC has been displayed and DTC/FF is
pressed, the scan tool returns to the "Priority" code.
To exit the enhanced mode, press SYSTEM MENU
to the System Menu. Select Global OBD, then press ENTER
to return to the Global OBD2 mode.
14
14
For technical questions, please call 1-888-866-5797
to return to the System Menu.
to continue.
to return to the System Menu.
to return to the System Menu.
again.
to return