Attach Kipping Bar To Uprights - PRx Performance Profile ONE Squat Rack with Kipping Bar Install Instructions Manual

Attach Kipping Bar To Uprights
1. Lay uprights on the ground facing upward. Leave space between for kipping bar.
2. Lay the kipping bar on the ground as shown in figure 1 with the center of the kipping bar off the ground.
3. Attach kipping bar arms as shown in figure 1 with supplied 1 1/2" hex head bolts and 5/8" lock nuts. Do
not fully tighten bolts.
4. Position the kipping bar so that hole B aligns with the top hole of both uprights as shown in figure 2.
Using the 4" hex head bolts and 5/8" lock nuts, attach the upright to hole B as shown in figure 2, (hand
tighten nuts onto bolts, they will be removed later to attach upper linkage arms)
5. Rotate the kipping bar roughly 90 degrees, until the kipping bar is in a similar position as shown in figure
3 and holes C of the kipping bar arms align with the 5th hole from the top of the uprights.
6. Using the 3 1/2" hex head bolts and 5/8" lock nuts, attach the kipping bar arms hole C to the uprights as
shown in figure 3. Make sure to position the plastic kipping bar spacer between the upright and kipping
bar arm on both connections, see figure 4.
7. Now is the time! Tighten the bolts in holes A and C. Leave the bolts in holes B hand tightened for now.
8. Team lift the rack into place (approximately 20" from the wall) and begin attaching linkage arms starting
at the top. (See next page)
Fig. 1
Fig. 3
A
Fig. 4
C
support@prxperformance.com
Fig. 2
B
7