Attach Linkage Arms To Wall Brackets - PRx Performance Profile ONE Squat Rack with Kipping Bar Install Instructions Manual

Table of Contents

Advertisement

Attach Linkage Arms to Wall Brackets
1. Place the small side of the plastic spacer (#2) in the straight, gas shock facing portion of unbent end
of the linkage arm (as pictured below).
2. Place the linkage arm with the plastic spacer (#2) facing the inside of the wall bracket "ear".
3. Attach using a 1 3/4" hex head bolt (#10) and 5/8" washer (#3) on the outside of the wall bracket "ear"
and a 5/8" washer and 5/8" lock nut (#4) on the opposite side.
4. Tighten using a 15/16" socket and 15/16" wrench.
*NOTE: DO NOT over tighten any of the pivot points. This may result in the rack feeling "stiff"
moving up and down. It should move up and down freely.
5. Repeat so all four linkage arms are attached to the wall brackets.
*NOTE: DO NOT attach the shocks to the wall brackets at this point of assembly.
6
3
10
(701) 566-0452
3
2
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Profile ONE Squat Rack with Kipping Bar and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents