Troubleshooting - Westinghouse WJS001 Operating Instructions Manual

Auto jump starter & mobile power
Table of Contents

Advertisement

Available languages

Available languages

G B
To Charge a Mobile Device
1. Connect a mobile device to the 5V output port of the Jump Starter with
the correct cable
2. Press the power switch button, charging begins once the LEDs light on
3. To stop charging, disconnect the cable.
*Tablet and smartphone are not included .
Power Level Status
Required capacity
to jump start a vehicle
Recharge the jump
starter before use
NOTE: A minimum of 3 illuminated LEDs is required to jump start a
vehicle. A fully charged unit is recommended.
Specifications
Jump Starter
Lithium-Polymer Battery
Battery Capacity: 15Wh 11.1V / 4000mAh
Start Current: 200A;
Peak Current: 400A;
Power Output: 12V Jump Starter
Operating Temperature: -20°C (-4°F) to +60°C (140°F)
Dimensions: 132mm x 69mm x 15mm (5.19'' x 2.71'' x 0.59'')
Mobile Power
Power Input: 5V
2A
Power Output: 5V
2A
Flashlight
0.5W LED
2.4 Amp USB Car Charger
Power Input: DC12 – 24V
Power Output: 5V
2.4A
WJS001 Manual 英法西中.indd 8-9
WJS001 Manual 英法西中.indd 8-9
4

Troubleshooting

Problem
Cause
Red LED remain
Low battery capacity
constant lit
• Reverse polarity protection
Red LED
is activated.
keep blinking
• If the vehicle will not start after
four consecutive attempts, the
red LED on the Jumper Cable
will illuminate.
• Short circuit protection is
activated
Red and Green
• The voltage of the car battery
LEDs are not lit
is higher than the Jump
Starter
Cautions
WARNING
• Never disassemble or attempt to open this unit.
• The unit may become warm under extended high power operation.
• Do not attempt to jump start your vehicle more than four consecutive times.
If the vehicle will not start after four attempts, consult a mechanic.
• Do not expose the product to fire, direct sunlight or excessive heat.
• Do not expose the product to any liquids.
• Clean only with a dry cloth; Avoid cleaning with abrasive substances
or chemicals.
• Recharge this unit fully every three months to be sure your Jump Starter
will be ready when you need it
• When not in use, the appliance should be stored in a dry, well ventilated
place out of the reach of children
• Children under the age of 12 should only use this product under adult
supervision.
WARRANTY
ONE YEAR LIMITED WARRANTY*
If you have any problems with the product, contact your local
distributor or Camelion Battery Co., Ltd.
Email us at: info@westinghousebattery.com
*The limited warranty term is one year beginning on the date of invoice
, WESTINGHOUSE, and I NNOVATION YOU CAN BE S URE O F are trademarks o f Westinghouse
Electric Corporation. Used under license by Camelion Battery Co., Ltd. All Rights Reserved.
.
For information contact
Camelion Battery Co., Ltd.
www.westinghousebattery.com
Made in China
WJS001201504GB
GB
Solution
Charge the Jump Starter
• Check the polarity of the clamps
and connect red clamp to the
positive terminal; black clamp
to the negative terminal.
• Unplug the Jumper Cable from
the Jump Starter and re-plug
again
• Remove the clamps. Do not
touch the red and black
jumper clamps together.
• Remove the clamps and
contact a mechanic.
5
2015/8/25 17:18:36
2015/8/25 17:18:36

Advertisement

Table of Contents
loading

Table of Contents