Installation; Installation Of Type I Camera; Ceiling/Wall Mounting Without Junction Box - HIKVISION DS-2CE10HFT-E User Manual

2 Installation

Before you start
Make sure that the device in the package is in good

condition and all the assembly parts are included.
Make sure that all the related equipment is power-off

during the installation.
Check the specification of the products for the

installation environment.
Check whether the power supply is matched with

your power output to avoid the damage.
Make sure the wall is strong enough to withstand

three times the weight of the camera, and the
mount.
If the wall is cement, insert expansion bolts before

installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact

your dealer or the nearest service center. DO NOT
disassemble the camera for repair or maintenance by
yourself.

2.1 Installation of Type I Camera

2.1.1 Ceiling/Wall Mounting without Junction Box

Before you start:
The installation of ceiling mounting and wall mounting
are similar. Following takes ceiling mounting as an
example.
Steps:
1. Paste the drill template (supplied) to the installation
place.
2. (Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
3. (Optional) Drill the cable hole, when the cables are
routed through the ceiling.
4. Attach the bracket to the ceiling, and secure the
camera with three PA4×25 screws (supplied).
Figure 2-2 Secure the Camera to the Ceiling
5. Connect the cables.
6. Power on the camera to adjust the view angle
according to the figure below.
Figure 2-1 Drill Template
2